Engineering Plastics

TECAPEEK CM GF15 natural (XP-92)- Stock Shapes

Chemical Designation

PEEK (Polyetheretherketone)


natural opaque


1.44 g/cm3


glass filled
production process: compression moulding

Main features

  • inherent flame retardant
  • good heat deflection temperature
  • hydrolysis and superheated steam resistant
  • good machinability
  • good slide and wear properties

Target Industries

  • oil and gas industry
Mechanical properties parameter value unit norm

Tensile strength



ASTM D 638

Elongation at break



ASTM D 638

Flexural strength



ASTM D 790

Thermal properties parameter value unit norm

Melting temperature





Made exclusively from Victrex® PEEK

Our information and statements reflect the current state of our knowledge and shall inform about our products and their applications. They do not assure or guarantee chemical resistance, quality of products and their merchantability in a legally binding way. Our products are not defined for use in medical or dental implants. Existing commercial patents have to be observed. The corresponding values and information are no minimum or maximum values, but guideline values that can be used primarily for comparison purposes for material selection. These values are within the normal tolerance range of product properties and do not represent guaranteed property values. Therefore they shall not be used for specification purposes. Unless otherwise noted, these values were determined by tests at reference dimensions (typically rods with diameter 40-60 mm according to DIN EN 15860) on extruded and machined specimen. As the properties depend on the dimensions of the semifinished products and the orientation in the component (esp. in reinforced grades), the material may not be used without a separate testing under individual circumstances. The customer is solely responsible for the quality and suitability of products for the application and has to test usage and processing prior to use. Data sheet values are subject to periodic review, the most recent update can be found at Technical changes reserved.


All data provided is for information and guidance only. Information above is not for design purposes and comes without warranty or guarantee with respect to the subject matter or fitness for purpose.